|
|
|
 |
 |
|
| Intel® Desktop Board D845WN |
|
 |
|
|
Contents
Jumper Location
Caution: Do not move any jumpers with the power on. Always turn off the power and unplug the power cord from the computer before changing a jumper setting. Otherwise, the board could be damaged.
The figure below shows the location of the jumper blocks.
![[Intel Desktop Board D845WN Jumper Diagram]](/support/motherboards/desktop/d845wn/img/wn_jump.gif)
Front Panel Audio Connector/Jumper Block
This connector has two functions: - With jumpers installed, the audio line out signals are routed to the back panel audio line out connector.
- With jumpers removed, the connector provides audio line out and mic in signals for front panel audio connectors. Depending on the design of the front panel audio connector card used, audio signals may be routed to the rear line out audio connector when the user unplugs from the front panel line out audio connector.
| Jumper Setting | Configuration | 5-6
9-10 | Audio line out signals are routed to the back panel audio line out connector. | | No jumpers installed | With jumpers removed, the connector provides audio line out and mic in signals for front panel audio connectors. Depending on the design of the front panel audio connector card used, audio signals may be routed to the rear line out audio connector when the user unplugs from the front panel line out audio connector. |
|
Note: When the jumpers are removed and this connector is used for front panel audio, the back panel audio line out and mic in connectors are disabled.
BIOS Setup Configuration Jumper Settings
The 3-pin jumper block determines the BIOS Setup program's mode. The table below describes the jumper settings for the three modes: normal, configure, and recovery. When the jumper is set to configuration mode and the computer is powered-up, the BIOS compares the processor version and the microcode version in the BIOS and reports if the two match.
| Function/Mode | Jumper Setting | Configuration | | Normal | 1-2 | The BIOS uses current configuration information and passwords for booting. | | Configure | 2-3 | After the POST runs, Setup runs automatically. The Maintenance menu is displayed. | | Recovery | None | The BIOS attempts to recover the BIOS configuration. A recovery diskette is required. |
|
Updated: Tuesday, September 18, 2001
This applies to:
|
|
|
|
End of Interactive Support AnnouncementThese products are no longer being manufactured by Intel. Additionally, Intel no longer provides interactive support for these products via telephone or e-mail, nor will Intel provide any future software updates to support new operating systems or improve compatibility with third party devices and software products.
THESE DOCUMENTS ARE PROVIDED FOR HISTORICAL REFERENCE PURPOSES ONLY AND ARE SUBJECT TO THE TERMS SET FORTH IN THE "LEGAL INFORMATION" LINK BELOW.For information on currently available Intel products, please see www.intel.com and/or developer.intel.com
|
|
Solution ID: CS-008936
Date Created: 27-Jan-2004
Last Modified: 22-Jun-2006
|
|
