|
Your Intel® Server Chassis SR2300 kit is designed to support the Intel® Server Board SE7500WV2.
The fan module and riser cards are installed for shipment, but you must remove and reinstall
them when you install the server board.
What Your Kit Includes
Your kit includes the following components:
- 2U rack-mount chassis featuring:
- Four hard drive bays with carriers and two bays with plugs
- Two hard drive bay plugs
- One bay for an optional DVD/CD-ROM drive/FDD module (comes with filler panel and plug)
- One bay for optional tape drive (comes with carrier and filler panel)
One 480 W SSI PFC non-redundant power supply or a 500 W 1+0 SSI PFC redundant power supply with one module and one blank
Two PCI riser cards for use with the Intel Server Board SE7500WV2
Three system fans
One internal USB cable, (connecting server board to front panel board)
One internal flex circuit cable, 100-pin (connecting server board to backplane board)
One internal SCSI cable (connecting server board to backplane board)
One internal front panel cable, 34-pin (connecting front panel board to backplane board)
One Resource CD-ROM containing drivers, utilities, and product guide
Mounting screws (server board)
Front, mid, or 4-post rack mounting kit
Items You Must Purchase Separately
The following components must be purchased separately:
- Front bezel (optional)
- Intel Server Board SE7500WV2 (SCSI)
- Minimum of one Intel® Xeon® processor
- Registered ECC DDR RAM memory DIMMs
- SCSI hard disk drives (HDD)
- Slimline DVD/CD-ROM drive/floppy disk drive module (optional)
- PCI add-in cards
- Hard drive carriers (over the four supplied)
- 500 W power supply module for redundancy
- System fan for redundancy
- Other peripheral devices (e.g drives, tapes drives, etc...)
This applies to:
| 
