|
Intel® Server Board S875WP1-E has 4 DIMM sockets, which can hold up to 4 GB of Unbuffered ECC and non-ECC DDR266, DDR333 or DDR400 memory using four 72-bit DIMM modules. The following memory features are supported:
- DDR266, DDR333 and DDR400 Unbuffered ECC and non-ECC compatible 2.5V modules (in compliance with the DDR JEDEC DIMM Specification).
- DIMMs with capacity of 128 MB, 256 MB, 512 MB, 1GB. Other DRAM sizes may function correctly but will not be validated.
- Minimum configuration is 128 MB using one 128 MB DIMM.
Note: This content is updated frequently, so please refresh your browser to ensure that you are downloading the most current version.
Caution: Third party memory vendors may use the same module part number with different
DRAM vendors and die revisions. To insure proper system operation, verify that each DRAM
vendor and die revision has been separately tested and qualified. Please notify CMTL if there is a discrepancy.
Note: This list is not intended be all-inclusive. It is provided as a convenience to Intel’s general customer base, but Intel does not make any representations or warranties whatsoever regarding the quality, reliability, functionality, or compatibility of these memory modules.
Note: PDF Files require Adobe Acrobat* Reader†
† This link will take you off of the Intel Web site. Intel does not control the content of the destination Web Site.
This applies to:
| 
