|
POST Error 0160, 84FF is being displayed during POST.
Updating the systems BIOS, BMC and FRUSDR with the latest version will remove this POST error. After the update, ensure that the Clear Event Log is enabled under BIOS. This will remove the historical data.
How do I configure onboard SATA raid?
The Intel Embedded Server RAID Technology supports two serial ATA ports, providing a cost effective way to achieve higher transfer rates and reliability. RAID 0 and 1 are both supported. For detailed information, please check the Intel® Embedded Server RAID Technology User's Guide [PDF].
Which RAID Controllers are compatible with Intel® Server Board SE7320SP2?
Please refer to Tested Hardware and Operating System [PDF] for more information.
Missing microcode message during POST with an installation of a new processor.
Check the compatibility of the processor against the server board being used. This information can be found under the compatibility section of the respective platforms. Perform a BIOS update to ensure that the processor microcode is integrated into the server board BIOS.
What do I do when a password is requested by the FRUSDR update utility?
Please refer to the Password May be Requested document for more information.
Tested Hardware and Operating System [PDF]
Please make sure you install your system fans and CPU fans to the correct connector on the system board. Then update FRUSDR following the instruction associated with the FRUSDR update.
This applies to:
| 
