|
The Intel® Server Board SE7320SP2 has 4 DIMM sockets supporting up to 8 GB of Registered ECC DDR266 or DDR333 memory using four 72-bit DIMM modules. These four DIMM sockets constitute two memory banks; Bank1 with contiguous sockets labeled DIMM1A & DIMM1B, and Bank2 with contiguous sockets labeled DIMM2A & DIMM2B. When memory is installed in pairs, DIMM Bank1 must be populated before DIMM Bank2. Memory within a DIMM bank must be identical. For customers requiring a lower cost configuration, a single DIMM may be populated in the DIMM1A socket. If this is done, the Intel® x4 Single Device Data Correction (Intel x4 SDDC) technology and memory interleaving will not be enabled. DIMM and memory configurations must adhere to the following:
- DDR266 or DDR333 registered ECC 2.5V modules (in compliance with the DDR JEDEC DIMM Specification)
- DIMM organization: x72 ECC
- Pin Count: 184
- Memory capacity: 256MB, 512MB, 1GB and 2GB
- Minimum configuration: 256MB using one single 256MB DIMM in socket DIMM1A.
- One or two memory banks may be populated
Note: PDF Files require Adobe Acrobat* Reader†
† This link will take you off of the Intel Web site. Intel does not control the content of the destination Web Site.
This applies to:
| 
