|
The Intel® Server Board SE7501BR2 accommodates one or two Intel® Xeon® processors with 512KB L2 Cache via two SKT604 604-pin
zero-insertion force (ZIF) sockets. The processors interface with the system bus at 533 MHz, backwards compatible with 400 MHz.
- When only one processor is installed, it should be in the socket labeled CPU1 and the other socket must be empty.
No terminator card is required to be installed, termination is provided on the server board.
- When using only a single processor, all 8 CPU standoffs on the chassis base plate are required to be installed when the board is being integrated. These standoffs are required to be fastened once the board is installed to withstand shock and vibration.
- When two processors are installed, ensure that the stepping is the same on both the processors.
Ensure that processors are on the supported list.
- Do not install the Processor Wind Tunnel when using the Intel® Server Chassis SC5200 with hot swap redundant power. Otherwise, use the thermal solution provided with your Intel® Xeon® processors
This applies to:
| 
