|
The Intel® Server Board SHG2 has specific requirements for the power sequencing and limits.
The power supply used must be either ATX12V or EPS12V design, otherwise the SHG2 server board will not operate.
These power supplies provide the additional power lead of 4-pin (or 8-pin) +12 volt connector.
The additional 4-pin (or 8-pin) +12V (see figure A below) connector should be connected to the
processor power connector located at CN7 (see figure B below), otherwise the system will not boot.
Note : Do not use a standard ATX power supply. The board will not boot with a standard ATX power supply.
Figure A: 12V Connector on the Power Supply. (image taken from SC5200 chassis)
Figure B : Processor power connector.
This applies to:
| 
