Support & Downloads

Browse By Product



Search
Support & Downloads
All of Support
This Category
This Product
 

Intel® Boot Agent

 
The Intel® Boot Agent can be used to boot a diskless workstation or to install an operating system on a new computer. The computer receives the boot image over Ethernet through an Intel® network adapter. Intel® Boot Agent is compliant to the PXE 2.1 standard. For network connections built into a computer, refer to the manufacturer's documentation for that computer.
  • Software and drivers
Boot Agent [PROBOOT.EXE]
Does the Intel® PRO/100 LAN on Motherboard (LOM) support the Intel® Boot Agent?
Does the Intel® PRO/100 VE support remote boot?
I backed up my boot image when I upgraded, but now I cannot find it on my hard drive.
I configured the Boot Agent to boot from the network, but it boots from the hard drive anyway.
I replaced my adapter with a new model, and now my old boot image no longer works.
RIS installation stops when connected to Port B of the Intel® PRO/1000 MT Dual Port Adapter.
Upgrading your PXE flash without a floppy disk drive requires DOS 6.22
When I disable the Boot Agent for LOM and on my NIC, my system still gets the PXE message.
How do I turn the Boot Agent off, or prevent it from running?
How to Add a Boot ROM to your PRO/100 Adapter
How to Update the Intel Boot Agent on Your Adapter
New Features of the Intel® Boot Agent
Supported flash devices
Tips and tricks for RIS iInstallations
Using the Intel® Boot Agent in a BOOTP environment
What tools should I use to upgrade the flash or enable/disable it?
Where can I find out about other remote boot resources?
Which Intel® Gigabit Adapters support the Intel® Boot Agent image?
Error: "PXE-E01: PCI Vendor and Device ID do not match"
Error: "TFTP: too many packages", when using BOOTP / TFTP to download an image
What are the descriptions of the error codes returned by IBAUTIL.EXE?
User Guide