Use the worksheets below to gather all the information required to configure your Elite Gateway*.

IP Parameters
Consult your network manager to obtain a static IP address for the Elite Gateway, and the information about the IP subnet mask and the default gateway for your network. Fill out the following worksheet before configuring the Elite Gateway.

IP address	_________________________________________
IP subnet mask	_________________________________________
Default gateway	_________________________________________

ATPM Destination Table

Local Destinations
Each telephony port of the Elite Gateway must be assigned a unique destination ID. Fill out the following worksheet for local destinations by designating each port a unique destination ID, then use the CLI command atpm dadd dest_id port port# for each entry in the worksheet to add it to the destination table.

The dest_id in the command corresponds to the Destination ID in the worksheet, while the port# corresponds to the Port#. You may alternatively use the web browser to add local destinations to the destination table.

Remote Destinations
Each remote Elite Gateway to be reached must be assigned a unique destination ID. Obtain the IP addresses of the Elite Gateway at remote sites and fill out the following worksheet for remote destinations by designating each remote Elite Gateway a unique destination ID, then use the CLI command atpm dadd dest_id h323 ip_addr [ip_port] for each entry in the worksheet to add it to the destination table.

The dest_id in the command corresponds to the Destination ID in the worksheet, the ip_addr corresponds to the Port#, the optional ip_port corresponds to the IP port. You may alternatively use the web browser to add remote destinations to the destination table.

IP address IP port (optional) Mode Destination ID ...   H323   ...   H323   ...   H323   ...   H323   ...   H323   ...   H323   ...   H323   ...   H323   ...   H323   ...   H323   ...   H323   ...   H323   ...   H323   ...   H323   ...   H323   ...   H323

ATPM Hunt Group Table
Several destinations may be grouped together to form a hunt group. When an incoming phone number matches the phone number of the hunt group, the Elite Gateway attempts to terminate the call at each of the destinations in the hunt group one at a time until a call is successfully completed.

Plan how destinations are to be grouped and fill out the following hunt table worksheet, then use the CLI command atpm hadd hunt_group_id hunt_type dest_id... for each entry in the worksheet to add it to the hunt group table.

The hunt_group_id in the command corresponds to the Hunt Group ID in the worksheet, the hunt_type corresponds to the Hunt Type (1 or 2), the dest_id... corresponds to the List of Destination IDs. You may alternatively use the web browser to add hunt groups to the hunt group table.

ATPM Address Table
Each phone number to be recognized by the Elite Gateway must have its first digits match an entry in the address table. Fill out the following address table worksheet and use the CLI command atpm aadd tel# min_digits max_digits hunt_group_id prefix_strip_len [prefix#] to add each entry in the worksheet to the address table.

The tel#; in the command corresponds to the Digits to Match in the worksheet, the min_digits corresponds to the Min. # of Digits to Collect, the max_digits corresponds to the Max. # of Digits to collect, the hunt_group_id corresponds to the Hunt Group, the prefix_strip_len corresponds to the No. of Digits to Strip and the prefix# corresponds to the Prefix String. You may alternatively use the web browser to add telephone numbers to the address table.

This applies to:

Elite Gateway*